The steps to clean the industrial sewing machine
(1) Cleaning of cloth feeding teeth remove the screws between the needle plate and the cloth feeding teeth, remove cloth wool and dust, and add a small amount of sewing oil.
(2) Cleaning of shuttle bed the shuttle bed is the core of the sewing machine and the most prone to failure. Therefore, it is necessary to remove dirt and add a small amount of sewing oil.
(3) Cleaning of other parts the surface of the sewing machine and all parts in the panel shall be cleaned frequently.
lubrication of the industrial sewing machine
Special sewing oil must be used. The sewing machine should be fully oiled after one or several days of continuous use. If you add oil between use, make the machine idle for one revolution to fully soak the oil and throw out the excess oil, and then wipe the machine head and table with a clean soft cloth to avoid soiling the sewing material. Then thread the rags, wipe them with the movement of the sewing thread, throw out the excess oil stains, and then carry out formal sewing until there are no oil stains on the rags.