Careful cleaning and cleaning to ensure that the parts of the computer car are clean is the basis for ensuring the quality of the assembly and prolonging the service life of the computer car. Especially the shaft sleeves, bearings, oil pumps, and parts containing rotating and swinging fittings should be cleaned carefully. If the various shaft parts are not cleaned when assembling them, it may cause the shaft sleeve to heat up too high and the transmission torque to be too heavy. In severe cases, it will accelerate wear due to debris and cause serious failures such as "seize", which will affect the overall performance of the machine.
All computer car parts that have undergone surface baking, electroplating and other surface treatments have adhesive layers on their assembly joint surfaces (including holes, grooves, planes and screw holes). Therefore, before assembly, these parts must be Process technical requirements, first carry out finishing, and then carry out assembly and deployment. If the assembly does not meet the specified technical requirements, the computer car will not work normally. The incorrect mutual position between parts and mechanisms also affects the working performance of the computer car.
The computer car is assembled for the first time or after a major repair, which has a great impact on the performance of the equipment. Computer cars with poor assembly quality have low accuracy, poor performance, loud noise, heavy torque, and short life. On the contrary, some parts with low accuracy can still be assembled after careful selection and assembly and precise adjustment. Better equipment.